Fan motor is not totally enclosed and should not be exposed to rain or moisture to prevent damage.
This 18" Misting Fan sits on either a tabletop or the floor to help keep you cool as you sit outdoors. These misting
fans attach to any garden hose.
The fan motor has 3 speed settings with the highest setting moving up to 4550 CFM of air. The three aluminum fan
blades are enclosed in chrome plated steel wire guards with a welded carry handle that acts as a cord wrap. Fan
head pivots 360° for tilt angle adjustments. Fan runs on 120 volts, is UL Listed, and meets OSHA requirements. Fan
motor is not enclosed so fan should not be left outdoors when not in use or in rain.
Attached to the front of the fan guard is one of our anodized aluminum mister heads that houses the misting nozzles.
This low pressure misting fan come with a garden hose swivel to attach to a garden hose. Each plastic misting nozzle
has a built-in mesh screen filter to prevent nozzle clogging and damage. In-line filters can be added below if you are
operating the misting fan with poor quality water or want to double filter your water.
Sizing Note: For most mist cooling applications we recommend ordering a misting fan with no more than 5 misting
nozzles. If you are using the misting fan for dust or odor control applications, then we recommend ordering a misting
fan with 7 or 10 misting nozzles. In the event the misting fan is putting out too much mist for your liking, you can
always plug misting nozzles off by purchasing a set of plugs below.
|Close-up of the aluminum misting head that is
attached to the fan. 3 Nozzle misting head is shown
|18" Low Pressure Floor / Tabletop Misting Fan
|Misting Systems & Misting Fans
FREE SHIPPING WITHIN THE USA!
Residential, Commercial, and Industrial Misting Applications
ORDER ACCESSORIES BELOW
Brass Plugs- 10 Pack (to plug off misting nozzles)
If your misting fan is making too much mist for your liking,
you can always remove misting nozzles and plug them off
with these brass plugs. These brass plugs are sold in packs
of 10 and are made from solid brass.
Pack of 10 Brass Plugs- $25.00
Low Pressure In-Line Filter
If you have a lot of sediment, minerals, or debris in your water we
recommend ordering this in-line filter. This filter will filter the water
before it enters your mister head to prevent nozzle clogging. If
ordered, we will install the filter for you.
PO Box 633
Orefield, PA 18069
A division of SnowStorm Snowmaking, LLC
Entire contents copyright 2007-2018. All rights reserved.